Engineering Stack Exchange
Engineering Stack Exchange

Questions tagged [abs]

8 questions
3
votes
0 answers

Forces on a wheel during braking (Quarter Vehicle Model)

I have created a simple xcos simulation for quarter wheel using the equations given at the bottom of the image. I understand the total torque on the wheel will be the braking torque and the friction torque. My question was right till the end the…
amekha
  • 31
  • 1
2
votes
1 answer

How well does epoxy bond to PETG / ABS vs Wood?

I know that PLA does not bond at all, just peel right off But i'm wondering about PETG or ABS Will they bond just as well as wood?
Simon
  • 115
  • 1
  • 10
1
vote
1 answer

Algorithm to detect flat tyre by comparing wheels speeds

So ABS systems are capable of detecting a flat tyre, because it will roll a bit faster (because of smaller diameter). What could be speed difference, needed to detect such fault? Do ABS systems only detect it when driving on smooth straight road,…
Ri Di
  • 121
  • 1
1
vote
1 answer

Injection molding: What is best for a dual cavity single mold?

I would like to understand what's the best optimization in terms of design for a single mold, dual cavity of a two-part box (top and bottom parts) which should be hold together with 4 screws without any clip. For other reasons not drawn, both parts…
gregoiregentil
  • 127
  • 5
0
votes
2 answers

Which glue is good for transparent ABS plastic and easy removal?

Hello all I need to glue some ABS plastic parts together some of them are transparent. I used AA glue before but it will make my transparent parts foggy and after sticking them together its nearly impossible to disassembly. So is there a better…
tempo3010
  • 5
  • 2
0
votes
0 answers

Long term deflection

I've been working with a team of 'designers' that are highly concerned over a potential failure mode of ABS plastic. Their theory is that under a static load well under the yield point of the material that a plastic ABS part will eventually stretch…
Diesel
  • 629
  • 7
  • 21
0
votes
1 answer

Temperature vs Material Properties - ABS

I'm working on a design that uses fairly large plastic components (ABS, ~400mm longest dimensions). I'm looking at adding a steel component that encapsulates this plastic part. And, the steel part needs to be tight against the ABS part. Because of…
Diesel
  • 629
  • 7
  • 21
0
votes
1 answer

Material Properties of ABS

I've been working on a design that requires a plastic snap feature. I've assumed up to this point that the material will be injection molded ABS, with material properties I pulled off of matweb. After several dozen iterations on the design, I've…
Diesel
  • 629
  • 7
  • 21