4

I've got a Vista64 machine behind a NAT router connected to the IPv4 Internet.

Teredo is enabled on my machine and I've got a IPv6 address with 2001:0: prefix. I can ping several servers in the IPv6 Internet (like force.ipv6only.se or ipv6.google.com), and tracert reveals that my IPv6 traffic is routed through a teredo relay. However, I cannot connect to or ping my machine from a machine in the IPv6 Internet. A tracert in this direction stops at the teredo relay.

What steps are necessary to connect to a Teredo-enabled server behind NAT?

dtb
  • 141

3 Answers3

2

Most likely a firewall issue. Ping is enabled if File and Printer Sharing is allowed. Vista's firewall, by default, only allows File and Printer Sharing on your local subnet. Thus, a machine from elsewhere on the IPv6 Internet is on a different subnet, and won't be able to access the File and Printer Sharing services, including Ping.

I haven't spent much time with Vista's firewall recently (I'm mainly a Linux user these days), so I can't give you exact steps to unblock this, but try temporarily turning off the firewall to see if it makes a difference.

Jeremy Visser
  • 1,474
2

Check if the machine with native IPv6 is not behind a stateful firewall which blocks icmpv6.

I had a similar problem, where a machine in a network with 6to4 was not able to connect to a machine using teredo in another network. Explicitly allowing icmpv6 in the IPv6 firewall in the 6to4 gateway (instead of just using ip6table's -m state --state ESTABLISHED,RELATED) was enough to cure the issue. This happens because teredo sends a IPv6 ping to the "native" (6to4 in this case) host, in a way iptables does not identifies as "RELATED", and will not work if that ping packet is dropped or rejected.

Blocking ICMP in general tends to only cause headaches, but I (mistakenly as it turned out) believed netfilter's state tracker would be enough to allow all needed ICMP packets.

CesarB
  • 2,558
1

If you are behind a NAT it is very likely that when the Teredo server tries to open a connection to you, but your NAT isn't forwarding the right port(s) on to you.

I'd find out which ports are required, or if possible forward all ports to your machine to test that it is indeed a port forwarding issue.

Check go6's wiki on Teredo and see if the section on "Teredo IPv6 addressing" gives you any insight to what else you might need to look into. You should be able to look at your assigned IPv6 address and then determine the ports you need forwarding.

jasonrm
  • 101