3

I have an Asus router with Asuswrt-merlin firmware installed. I have the DHCP server on my router give out addresses in the 192.168.0/24 subnet. My OpenVPN server is configured as seen on this image. The VPN subnet / netmask is 10.8.0.0 / 255.255.255.0. The Push LAN to clients, and both the DNS settings are set as shown in the image. However I cannot connect to my local LAN when connected to the VPN server through TUN. When I switch to TAP I can make it work because then the VPN subnet / netmask is the same a my local LAN and the connected VPN clients get an IP address from the LAN DHCP pool, however I cannot connect my Android phone/iOS device to the VPN server because they don't support TAP, only TUN.

How can I access my local LAN through TUN?

mmjmanders
  • 131

3 Answers3

2

Try these, with these you'll need a username/password accounts setup additionally.... if that doesn't work you'll need to post more details and your logs.

Whenever you make changes, always export and use the new config.

Jacob Evans
  • 8,431
1

Hi all you need add route with metric

route add -p 192.168.0.0/16 (router-local-ip) metric 1

*run cmd as administrator.

kgimpel
  • 227
-1

This almost worked perfectly for me with the same problem! Is network discovery enabled? I'm using my Apple TV from a remote location (client) with a router to router tunnel. When I try to access my home network while at home (server side), all the devices just show up. When I try to access it remotely, I need to enter in the IP addresses for the devices. Any thoughts?

user593869
  • 1